Today, we will continue to learn about other reasons and solutions for the blockage of the rotor, discharge elbow or feeding pipe during the use of the shotcrete machine for dry material. Let's look at the reasons and what we should do:

Reason 1 and troubleshooting method:

Reason: The conveying air pressure is too low

Troubleshooting method: stop the motor and air supply hose. If the rotor is blocked, disassemble the air inlet pipe and upper flange, and clean the rotor cavity with a brush

Reason 2 and troubleshooting method:

Reason: The section of the air inlet pipe is too small, and the air supply volume of the air compressor is small

Troubleshooting method: replace large section air hose and large capacity air compressor